HKM-115091 Smart 50-Inch Bladeless Tower Fan Cooling and Heating with Remote Control and Air Purifier for Home Office

HKM-115091 · Bladeless Tower Fan · () · 20 kg gross

50-Inch Bladeless Tower Fan with Ceramic Heating and Cooling50-Inch Bladeless Fan Heater and Cooler

A 50 in (127 cm) bladeless tower that runs cool air in summer and 1200W ceramic heat in winter, with an eight-speed fan, 80 degree oscillation, a HEPA and carbon filter, a remote and a 1 to 8 hour timer. One tower for the whole year instead of a fan in the cupboard and a heater in the loft.

The blade-free column pulls air through the base and pushes it out of a narrow slot, so the airflow is smooth rather than chopped. That is why it moves a room without the buffeting a bladed fan gives you at close range, and why a child or a cat can put a hand into the tower without touching anything that spins.

It suits a bedroom, a living room or a home office where the same corner has to work in January and July. It is not an air conditioner: the cooling side moves air, it does not chill it, so a 95 F room stays 95 F and just feels less still.

At a Glance

• 50 in Tower — 127 cm column, floor standing, 12 in base
• Cooling + Heating — Fan in summer, 1200W PTC ceramic heater in winter
• 8 Wind Speeds — Plus natural, sleep and auto modes
• 80 Degree Oscillation — Wide sweep, switchable to fixed
• HEPA + Carbon Filter — Traps dust and odour before the air leaves the slot
• Bladeless Column — No exposed blades, easy to wipe clean
• Remote + Panel — Both work, plus a 1 to 8 hour timer
• 30 to 45 DB — Sleep mode drops the fan to its quietest step
• Tip-over Cut-off — Heater stops if the tower is knocked over
• 6.5 kg Net — 20 kg boxed, 22 x 22 x 100 cm carton
• 2 Finishes — Champagne Gold and Mist Blue
• 120 V AC, 60 Hertz — US plug, 45W fan / 1200W heat

What the Tower Is Made Of

The column is ABS with a matte finish, mounted on a weighted base so a 127 cm tower does not walk across a wooden floor when the oscillation is on. The slot runs the full height of the column, which is what gives the wide, even sheet of air rather than a narrow jet.

Inside the base there is a cylindrical HEPA filter and a carbon pad. Air is pulled in at the bottom, passes through both, and leaves through the slot, so dust and cooking smells are handled before the air reaches you. The filter bay opens without tools.

The heater is a PTC ceramic element in the base duct, rated 1200W. PTC elements self-limit their temperature, so the air leaving the slot stays in a narrow band instead of climbing until the plastic smells hot, and the element shuts off if the airflow stops. That last point is the difference between a tower heater you can leave in a nursery and one you cannot: if the impeller stalls because the intake is blocked, the element loses its airflow and cuts out instead of cooking the duct. The base also carries a tip-over switch, so a tower knocked over by a dog stops heating before it touches the carpet.

• ABS column, 50 in / 127 cm tall, matte finish
• Weighted base, 12 in diameter, non-marking feet
• HEPA plus activated carbon filter, tool-free bay
• 1200W PTC ceramic heater with airflow cut-off
• Braided 6 ft cord, 120V US plug

Two details decide whether a bladeless tower feels cheap. The first is the impeller balance: a poorly balanced mixed-flow wheel makes the column hum at step three and up, and no amount of foam in the base hides it. The second is the slot width. Too wide and the airflow collapses into a lazy puff; too narrow and it whistles. This tower runs a 2 mm slot over the full 127 cm, which is why the air arrives as a sheet rather than a puff.

How the Air Moves

A brushless DC motor drives a mixed-flow impeller inside the base. Because the impeller is hidden, the noise it makes is mostly airflow, not motor whine: measured at one metre, the eight steps run from about 30 dB on sleep to 45 dB on high.

Cooling mode has eight fixed speeds plus natural (the fan cycles up and down to mimic a breeze) and sleep (speed drops every half hour). Heating mode has two levels, 1000W and 1200W, and it will not run unless the tower is upright and the base switch is closed.

Oscillation sweeps 80 degrees and can be stopped wherever the head is pointing. The remote mirrors every panel control, including the display dimmer, which matters if the tower sits in a bedroom.

On the heating side the thermostat is the part people either love or ignore. It reads the air at the intake, not at the far wall, so the room settles a degree or two below the number on the display. Set it two degrees higher than you would set a wall thermostat and let the tower cycle; chasing the number by turning it up just keeps the element on and the bill climbing, without making the far end of the room any warmer. If the tower is your sole heat in the room, give it twenty minutes before you decide it is not working.

Where It Works and Where It Does Not

Suited to a room up to about 300 sq ft with the tower in a corner and the slot aimed across the seating rather than at one person. On a desk it is wasted: the airflow is wide by design, so close range feels weak. Put it two to three metres away and it reads as a gentle whole-room breeze. The column is 127 cm tall, so the slot sits above the back of a sofa and the air reaches seated people rather than the floor in front of them.

The heating side is a supplement, not a central heating replacement. In a 120 sq ft bedroom it will take the chill off in about 20 minutes; in an open-plan space it will run continuously and cost money without changing the room much. It is also not an air conditioner: on a hot day the cooling mode moves air, and that is all.

• Bedroom: sleep mode plus display off, timer 2 to 4 hours
• Living room: oscillate across the sofa, step 4 to 5
• Home office: fixed aim, step 3, heater on low in winter
• Not for: bathrooms, kitchens with grease, outdoor use

What Arrives and What It Weighs

Stand the tower upright for an hour after unpacking before the first heat run, so any oil in the heater duct settles. Keep the carton for the first month in case a part arrives damaged.

Two Finishes

Champagne Gold is a warm metallic beige with a satin sheen; Mist Blue is a pale grey-blue that reads almost silver in daylight. Both use the same black base and the same smoked display, so the difference is the column only.

The finish is painted rather than anodised, so a scouring pad will dull it. Wipe with a damp microfibre cloth and keep acetone and citrus cleaners away from the column.

Filter, Dust and Winter Storage

Vacuum the intake grille every two weeks in season; a clogged intake is the usual reason a bladeless tower feels weak.

Rinse the HEPA cartridge under a tap every two months and let it dry fully before refitting; a damp filter smells.

Replace the carbon pad every season. It is the part that handles cooking and pet odour.

Before storage, run the fan on high for ten minutes with the heater off to dry the duct, then coil the cord loosely and cover the tower.

If the tower starts rattling, stop it and check the two base halves are still tight. The base carries the motor, and a loose base on a wooden floor will transmit vibration into the column like a drum.

In heating mode the element can smell faintly for the first hour. That is protective oil burning off; it should not return. If it does after a week, stop using the heater and contact support.

Specifications

Frequently Asked Questions

Shipping, Returns and Warranty

Every HKM-115091 ships with the store policies below. Returns and warranty requests follow the same coverage window shown in the four panels, and support answers within one business day.

The HKM-115091 is one tower for a room that has to work in both seasons: an eight-speed bladeless fan with a washable HEPA filter for summer, and a 1200W PTC ceramic heater for winter, in a single 127 cm column that never has to be carried up from the basement twice a year. It is quiet enough for a bedroom on sleep, wide enough for a living room on step five, and honest about what it cannot do: it moves air, it does not refrigerate it.